Painting Like a Pro — Step and Touch Ups — Pretty Handy Girl

Painting Like a Pro - Step and Touch Ups - Pretty Handy Girl

Painting Like a Pro Step 3. Painting and Touch Ups

Welcome back, I hope you are ready to paint with me today! If you are just stopping by and havent prepped your room for painting, you may want to take a moment to read Painting Like a Pro Step 1 and Step 2 .

Before

After

  • paint tray
  • two plastic grocery bags (optional)
  • a paint roller with a regular nap for smooth walls. If you have a textured wall (orange peel, cottage cheese or as My Boys Teacher showed me: sand texture) you may need a thicker napped roller.
  • 2.5 angled painters brush
  • edger (optional)
  • Painters tape (I prefer the Scotch Blue Delicate Surfaces tape)
  • a damp rag
  • sanding block with 200 grit or higher sand paper
  • damp sponge with a bucket of fresh water
  • x-acto blade (optional)
  • small flat artists brush

Go ahead and pour your paint into a paint tray (make a liner with grocery bags as I show HERE .)

Only fill the tray about half full (more than shown in the picture), you need some blank space at the top to squeeze the excess paint out of the roller by rolling it back and forth.

Painting Walls and Ceilings:

When I paint a room, I always paint the ceiling first, unless it REALLY doesnt need painting. It is more efficient to paint the whole room while you have the tarps down and supplies out. Besides, you know you wont go back and paint the ceiling another day. Am I right?!

You can paint the ceiling the same way I paint walls, just use an extension pole and a two-step ladder for painting the border. Dont worry about taping off the walls or trim right now. Ill tell you when to tape later. The only time I would use tape now, is if I need to mask off something like the vanity, a light fixture or a wall Im not going to paint.

1. Begin by painting the border on your wall. Use either a paint brush or the edger. If you are using the Aura paint, let this border dry before you move onto the next step. If you are using another brand/type of paint, work quickly and move onto the next step.

2. Use your roller to roll out a 3 4 foot W shape. Try to roll into the edge while it is still wet (unless you are using Benjamin Moore Aura paint.)

3. Roll the roller back and forth, up and down and in random directions until you have filled in a 4 square section of wall.

4. Roll the roller very lightly over your square to make sure the coat of paint is even; feather the edges; and to rid the wall of any start and stop roller marks.

Start on the next section with another W shape and repeat steps 1-4 until you have covered your wall in paint. Then move on to the next wall. Keep in mind that you will need at least two coats of paint. Youll get a more durable paint job, more even coverage, and it will look professional if you use two coats of paint. So, own up to the fact that you will need two coats!

A few words of caution while painting:

  • If your paint has started to dry and <> you see a spot you missed or a bug in your paint, resist the urge to roll over it. Wait until it dries, then sand or paint the messed up area.
  • It is best not to overload your roller with paint. Too much paint can drip and run. If that happens, use your damp rag to wipe it up immediately. And remember, you are going to use two coats, right?!

Now that you have completed the first coat (and it is dry to the touch), pull out the sanding block. Lightly sand all the walls. You are just knocking down any bumps (or bugs) and giving your paint layer a little tooth for the next coat to adhere to.

Then wipe down your walls with a damp sponge to remove all the sanding dust.

The sanding between coats may seem like overkill to you, but trust me, the sanding step makes a difference! And you wanted to know how to paint like a professional, didnt you?!

Now, go ahead and paint your second coat of the wall color repeating Steps 1-4 above, for  painting a border and rolling the paint inside.

Done? Well, not quite. Remember when I showed you this the other day?

Yes, the wall paint is on the trim. That is okay, I want it like that. I knew I was going to paint the trim and wanted to make sure that the wall color went right up to my trim, its all by design baby, trust me.

At this point you have painted the ceiling and all of the walls in your room. If you are sure your walls are dry (at least 1 hour or more), then you can move on to the trim.

Painting the Trim:

Now you can go ahead and tape off the edge of your walls where they meet the moulding. Then use the matte medium  trick I showed you HERE (or you can use a small amount of wall color if you like) to seal the edge of the tape on the wall side.

Go ahead and paint all your trim with a 2 1/2 paint brush dipped in a small bucket of trim paint. I prefer Purdy brushes because they last for years! See my post on cleaning brushes HERE to see how I protect them from wearing out.

Be sure to put two coats of paint on the trim, this will help to keep it looking new and stand up to the Matchbox Demolition Derby games that ensue in your home. (What? You dont have those games in your house? Lucky for your home.)

When the paint has dried partially (dont wait too long), go ahead and remove all the tape.

If you dont have any imperfections, you better go play the lottery right now! If you are human and normal you will have a few. No big deal. You can use one of two techniques (I use both).

1.Gently scrape any excess paint off with an x-acto blade.

2. Use a small square artists brush and paint over any seepage. I like to shake my can of paint and remove the lid to expose just enough paint on the lid for touch ups.

Horray, you are done! Now you can tell your friends, Im sorry I cant give you the name of my painter, because I painted the room myself!

Here are the before and after pictures of our half bathroom. I am LOVING the results. I have a few more tutorials for you from this project. I promise, they will come in due time.

Before — Beech Wood Vanity


Leave a Reply